PDA

View Full Version : BEER is working

Ryan Gee
11-02-2006, 05:42 PM
I just sat in the garage a drank a six pack while looking at this... VG30E anyone?

Here is a link to the pics of the engine...

http://nissansas.com/rigs/ryan/hb/engine/engine_rebuild.htm
Packman5280
11-02-2006, 06:15 PM
dats secksy
ChefTyler
11-02-2006, 06:28 PM
sexy doesn't even BEGIN to describe it
Ryan Gee
11-03-2006, 07:06 AM
When it is gone the price will be a little more than one of those low mileage JDM engines on ebay. However it is kinda nice to see how it all works!
JayRyan
11-03-2006, 08:38 AM
:crazy: Is the charger going on that one? Ebay has the Eaton for around $150. '

...I need to find me that a VG33 to build up...
Ryan Gee
11-03-2006, 08:53 AM
Yessir! She is going to be built for that purpose! This next week will be pics of it getting assembled. The SC will be later. Chris almost had a SC for me this last week! I couldnt make it down to pull-n-save in time to grab it! Thanks for trying Chris!!!
Ryan Gee
11-05-2006, 06:07 PM
Getting the heads together....

http://nissansas.com/rigs/ryan/hb/engine/engine_rebuild.htm



http://nissansas.com/rigs/ryan/hb/engine/engine%20(17).JPG
ChefTyler
11-05-2006, 07:45 PM
Damn you! but that's awsome!
Ryan Gee
11-06-2006, 08:02 PM
These perches would work really well for an Xterra spring over conversion.

http://nissansas.com/rigs/ryan/hb/frontaxle/DSCF2830%20%28Medium%29.JPG

http://nissansas.com/rigs/ryan/hb/frontaxle/DSCF2832%20%28Medium%29.JPG

http://nissansas.com/rigs/ryan/hb/frontaxle/DSCF2834%20%28Medium%29.JPG
Packman5280
11-07-2006, 09:03 AM
you mean perches? where did you get em?
Ryan Gee
11-07-2006, 09:25 AM
opps, perches! thanks bro!

Got them on ebay.. for around 10 bucks each!:crazy:

(got 4, so front and rear.)
Ryan Gee
11-11-2006, 03:17 PM
The pistons have homes! This engine is from a Nissan Quest.. they are a non-interference engine. The top of the pistons are carved out so if the timing belt lets loose the valves don't hit the pistons. Kinda neat!


http://nissansas.com/rigs/ryan/hb/engine/DSCF2843%20(Medium).JPG
MaxdaSwede
11-13-2006, 12:45 AM
hey those are the perches im uses for my soa next week.we will see how it goes.
Max
Ryan Gee
11-13-2006, 07:45 AM
The only thing I can think of that will not work with your Nissan spring is the centering pin hole. It is a little larger than the head on the Nissan centering pin, so it would allow your axle to move around just a bit. 4 wheel parts has the right pin size for the hangers, however it requires drilling the holes in your springs just a hair. Being the pins have to be pulled and flipped anyway, it doesn't require much time.