Sas Solution?

[JBDevega]

http://www.purenissan.com/front_cv_shaft.htm

I have a 95 pathfinder but i got thinking about it and im pretty sure that the xterra vg33 driveshaft is the same length as a pathfinder vg30 driveshaft. so this could work for my applicantion? or am i back to trying to figure out how to make a custom driveshaft?

[JeffW]

If you're custom SASing, you should determine where your front axle will be prior to deciding on a driveshaft.

[bogof]

Wait till after the swap. That driveshaft is for the Calmini SAS, and might not work for your aplication.

www.highangledriveline.com
www.4xshaft.com

both make really nice driveshafts. Jess with high angle driveline is a really good guy with a lot of knowledge.