89 Hardbody v6 4x4 driveline vibration

[Ghettoguy4x4]

So I just bought an 89 Hardbody the ft u joint was worn pretty bad. I just put a new ft u joint on it got rid of the clunk. Now I have a constant driveline vibration especially on the highway, I'm guessing my driveshaft was worn/out of balance. Does anyone know of a good place to take it to to get it machined(if it's not too worn). Or does anyone have spare for a 89 d21 v6 4x4 5 speed. Thanks all!
:beermug:

[CurleyMan]

Search co4x4 I recently read a thread in the general4x4 section were people reccomended a local driveshaft shop. I will not stray from tom woods but the one they mentioned in Denver sounded cheap and easy.

[Packman5280]

what part of the driveshaft wears, and how does a machine shop fix it? never heard of that before.

[CurleyMan]

It probably just needs to be balanced!

[Ghettoguy4x4]

Yeah I'm thinking it's out of balance as well. I searched on there but I couldn't find anything except this shop http://www.rmdriveline.com/ anyone used them?

[Alpine Spirit]

Truck Parts Specialists off of I-70, they rebuilt my front just over a year ago.

[itsme1738]

frontrange driveline...they do all our crane work+ they do racing stuff for my boss 9 sec car never had a problem with them they are at federal and oxford

[Ghettoguy4x4]

Truck Parts Specialists off of I-70, they rebuilt my front just over a year ago.

Do you remember about how much? What did they do to it? I don't think i can balance it myself? Not sure though?

[CurleyMan]

303-783-9954 frontrange driveline is who most of the co4x4 guys used. I think the post was on the second or third page in general4x4 "I need a driveshaft".

[Alpine Spirit]

Do you remember about how much? What did they do to it? I don't think i can balance it myself? Not sure though?

They had to rebuild the Cardan Joint... about 175. But the had to basically replace the upper part and then rebalance it.